For those who want to know whether their electronic components or circuits work, it can be easily tested at home with multimeter. Basically, there are three primary electronic components that are used in the circuits. The capacitor can store energy in the electrical field, the inductor can store energy in the magnetic field, and the resistor can increase the potential difference between two points. At this time, this article is going to give you some easy tips to test electronic components with a multimeter. So, just take a look at the tips below.
Firstly, you need to test the resistor by turning the multimeter switch to the resistor setting. It is indicated by the omega symbol. After that, you should place the dial to the lowest setting above the component resistance. You can check it by reading the color bands. If you find that the component is unlabeled, then you have to set the dial to the lowest setting.
Secondly, you need to place one probe on the each side of the resistor. It is usually on the extended lead. If you find that the measurement is not conclusive, you should adjust the dial up or down the magnitude as needed. It is known that resistor is an electronic component which resists the flow of the electric current for increasing the voltage. It is used for controlling the voltage or current. The capacitor can hold the energy in the electric field and it is often used for storing the charge for later, or for controlling current.
Thirdly, you need to test the inductor by turning the multimeter switch to the inductor setting. It is usually indicated by the letter H. In this step, you should place the dial to the lowest setting above the component inductance. If it is found that the component is unlabeled, you need to adjust the dial up or down the magnitude as needed. The inductors are storing energy in the magnetic field which is generated by the electric current passing through coils of wire. They can be used for simply storing energy or controlling the electric current.